In this article I will discuss how to apply the settings Bullet 2HP as BTS transmitter that can be received directly by the user's laptop (Access Point) and at the same time using one of the first experience Ubiquiti products. Following the steps of his setting:
1.After all the instruments have been correct installation, connect the UTP cable to the computer via
1.After all the instruments have been correct installation, connect the UTP cable to the computer via
POE mate with a straight connection type and then note the IP address bullet which by default is
192.168.1.20, then set the IP for example 192.168.1.21 pal Lan computer then fill in the Default
2.And than please my friend open the browser and then fill in the address bar 192.168.1.20, so if the
correct setting will appear AirOS bulletnya early, so my friend can see on the Main tab there is
information about setting the default bullet.
3.For start setting the bullet as a transmitter, and then select Link Setup tab and set the Wireless Mode
correct setting will appear AirOS bulletnya early, so my friend can see on the Main tab there is
information about setting the default bullet.
3.For start setting the bullet as a transmitter, and then select Link Setup tab and set the Wireless Mode
on Point or WDS Accsess it, if my friend wanted the bullet as a receiver in this case acts as a client then
select Station. Transmitter is loaded SSID name pal. Because the bullet I want to make as a transmitter
that can be received directly by the user's laptop then on my chosen mode of IEEE 802.11 B / G Mixed,
then to Channel Spectrum Width at 20MHz and should select its consumer and small channel selected
Output Power 20 dbm. 4.And than set the default setting bullet Network Mode Network in Bridge mode, static IP address with IP
address bullet loaded as follows:
IP Address: 192.168.1.20 Netmask: 255.255.255.0 IP Gateway: 192.168.1.1 Primary DNS IP:
IP Address: 192.168.1.20 Netmask: 255.255.255.0 IP Gateway: 192.168.1.1 Primary DNS IP:
202.134.0.155 Secondary DNS IP: 202.134.0.62 IP set wifi laptop 5.Kemudian pal same IP bulletnya
because bullets are in bridge mode. Until this stage settings as Accsess Point bullet is finished and then
do the ping, if the settings are correct reply.